HP 2000CP 2500CP - Manual (Page 49)

2-14 System Error Codes HP DesignJet CP Series Printers
System Error: 010039
Problem Description: A Printhead voltage could not be set - Carriage
PCA Failure
Corrective Action: Try the following:
D Make sure that the Trailing Cable is connected
correctly.
D Replace the Trailing Cable ' page 8-36.
D Replace the Carriage Assembly ' page 8-42.
Only replace one component at a time and
check if the error has gone before replacing
another component. Using this procedure
you will be able to determine exactly which
component failed.
System Error: 010040
Problem Description: The Ambient Temperature measured is out of the
normal range.
Corrective Action: Try the following:
D Make sure that the Trailing Cable is connected
correctly.
D Replace the Trailing Cable ' page 8-36.
D Replace the Carriage Assembly ' page 8-42.
D Replace the Electronics Module ' page 8-6.
Only replace one component at a time and
check if the error has gone before replacing
another component. Using this procedure
you will be able to determine exactly which
component failed.
System Error: 010041
Problem Description: Problem in setting the Printhead Voltage.
Corrective Action: Switch the Printer OFF and ON again. During
initialization another error code will appear. Refer
to the relevant error code for further information.