HP 3150 EN - Manual (Page 44)

42 Installation and operation EN
Communication Error An error occurred while trying to transmit
a fax. Brief descriptions of communication
errors are listed below:
60 no RTC at end of fax
81 memory filled up
82 fax was too short
84 power fail while receiving
85 failed to train
86 in ECM, fax data had error(s)
87 NEC failed to decode (T.4 or T.6
coding error
88 received scan line exceeds 13 sec
(T.4-3.2)
89 modem setup timeout
90 low speed command time out
91 bad low speed command
92 transmit error: no DIS
93 transmit error: no answer
94 transmit error: canceled by operator
95 transmit error: failed to train
96 transmit error: busy
97 transmit error: no dial tone
100 poll-in error: no document to poll
101 document jam
102 receive error: too many mailbox
logs
103 receive error: had poll document but
no memory for receive
104 transmit error: no MCF
105 image processing chip fell behind
106 transmit: modem output buffer error
107 PIN received
108 RR/RNR timeout
109 generic ECM error
110 possible missing/partial pages in
ECM
111 T4 bit not set in DIS
112 wrong password
113 communications error in remote
setup (JetFax only)
114 fax document was lost (JetFax only)
115 blacklist
116 SUB/PWD error
117 timeout waiting for image
processing chip
118 no fax detected
119 remote access
120 caller disconnected prematurely
Try again to send the fax.
Try to send the fax to another fax
machine.
Make sure the telephone cord is
securely connected. Then, check for a
dial tone on the phone line by pressing
M ANUAL D IAL .
Make sure the phone line is working by
disconnecting the HP LaserJet 3100/
3150 product, plugging in a telephone to
the phone line, and making a voice call.
Connect the product to a different phone
line.
Reset the product by pressing and
holding
S TOP /C LEAR for seven seconds.
Wait and try resending the fax later.
Table 9. Control panel messages
Message Cause Solution