HP 3150 EN - Manual (Page 205)

EN Fax trace report 203
Table 21. Appropriate responses
Commands Comments Appropriate responses
(NSF) (CSI) DIS Identifying capabilities: from a manual receiver
or an auto-answer unit (NSC) (CIG) DTC
(TSI) DCS
(NSF) (CSI) DIS
(CRP) (TSI) (NSS)
(PWD) (SEP) (CIG) DTC
(PWD) (SUB) (TSI) DCS
(NSC) (CIG) DTC Mode setting command: from calling unit (TSI) DCS
(NSF) (CSI) DIS
(PWD) (SEP) (CIG) DTC Poll operation (CRP) (TSI) (NSS)
(TSI) DCS
(TSI) (NSS) Mode setting command: from manual
transmitter or automatic receiver CFR
FTT
(NSC) (CIG) DTC
(PWD (SUB) (TSI) DCS This command is always followed by phasing/
training. (NSC) (CIG) DTC
CTC Mode setting command: from the transmitter to
the receiver (CTR)
(CRP)
(EOR-NULL) Indicates the next block transmission from the
transmitter to the receiver (ERR)
(RNR)
(CRP)
Any one of the following:
z
(EOR-EOP)
z
(EOR-EOM)
z
(EOR-PRI-MPS)
z
(EOR-PRI-EOP)
z (EOR-PRI-EOM)
The receiver (ERR)
(RNR)
PIN
(CRP)
Any one of the following:
z
MPS
z
EOP
z
EOM
z
(PRI-MPS)
z
(PRI-EOP)
z
(PRI-EOM)
Post-message commands MCF
RTP
RTN
PIP
PIN
(CRP)
(PPS-NULL) Post-message command for a partial page
from the transmitter to the receiver (PPR)
MCF
(RNR)
(CRP)
Any one of the following:
z
(PPS-MPS)
z
(PPS-EOP)
z
(PPS-EOM)
z
(PPS-PRI-MPS)
z (PPS-PRI-EOP)
z
(PPS-PRI-EOM)
Post-message commands for a complete page
from the transmitter to the receiver (PPR)
MCF
(RNR)
PIP
PIN
(CRP)
(RR) Ask for the status of the receiver: from the
transmitter to the receiver (RNR)
(ERR)
MCF
PIP
PIN
(CRP)
DCN Phase E command None