EverFocus EDR410H - Manual (Page 54)

3.10 Con
Diagram 3.18 is a
enu is for setting up
a connection fro nsfer instructions or
formation using the HyperTerminal program in Windows. In the Control Setting
enu the following fields are defined as follows:
RS232:
¾ RS232 Baud Rate: This field is to set the speed at which is used to
transmit instruction or information through the RS232 port on the DVR.
There are six different speeds, 1200 BPS, 2400 BPS, 4800 BPS, 9600 BPS,
19200 BPS, and 3840 BPS. The default setting from the factory is 9600
BPS. To change this, simply use the Jog Dial on the DVR. Press the
Enter key to make your selection.
¾ RS232 Stop Bit: This field is to set the stop bit for the RS232
connection. There are two different stop bits, 1 or 2. The default in the
mply use the Jog Dial on the DVR
ke your selection.
¾ RS232 Parity: This field is to select the parity level at which you will be
connected. You can choose between None, Odd, or Even parity levels.
trol Setup Menu
Diagram 3.18
screen shot of the Control Setting Menu. This m
m the digital recorder to a computer to tra
in
M
DVR is set to 1. To change this, si
Press the Enter key to ma .
46