EverFocus EDR410H - Manual (Page 20)

2.1 Basic Wiring Instructions
Please refer to diagram 2.1 on page 11 to assist you with this portion of the
power source or adapter into the power sock
ƒ Note: Do not plug the digital video recorder into the same
power source as the cameras.
ital
rder shown in diagram 2.1.
ƒ Note: At least one camera must be connected before the system
to take effect.
nnected to the
audio input terminal at the rear panel.
¾ Audio Output: Connect the speaker or other audio listening devices to the
¾ Ethernet: The digital video recorder may be viewed from a PC via the LAN
¾ RS232/RS485: The digital video recorder may be ol PC via
RS232/RS485
ƒ
Monitor:
nitor. The main spla selected live or recorded cameras in any
ƒ connected i
configuration changes, en in menu, or do a playback at
the machine.
¾ Call Monitors: Connect the call monitor output connectors to a call monitor.
The call monitor display selected live cameras in full screen format.
ƒ Note: The call monitor will only display one full screen camera
at a time.
installation.
et shown in ¾ Power: Connect the
diagram 1.
¾ Cameras: Connect each cameras video output to the video input on the dig
video reco
is running for the auto detection of video standard
¾ Audio Input: The camera audio output or Microphone is co
recorder. audio output terminal on the back of the digital video
connector using a RJ45 Ethernet cable.
led from a contr
.
Note: This can be done using a serial cable.
¾ Main
mo
available format.
Connect the main monitor output connector to a main
monitor di ys
Note: The main monitor must be n order to make
ter the ma
12