EverFocus EDR410H - Manual (Page 38)

NO CHANGE: No change on the display in the main monitor when
motion occurs.
SEQUENCE: Display in the sequence mode when motion occurs
(Full Screen of selected cameras).
¾ the SUMMARY table. All
alarm’s statuses are shown in SUMMARY tables. These tables are for
checking alarm overall statuses, but not for setting.
¾ Press SELECT to Edit (MOTION AREA) Enter a desired channel
and edit a motion area. Please make sure that
MOTION is set as “Enable” before entering the motion detection area.
ƒ
ƒ To clear the motion entire area: Press PLAY to clear the entire
ƒ If you forget the motion grid commands: Press DISPLAY to get
a hint window (shows below) in motion edit mode.
In the motion edit mode:
The default motion area of each camera is
entire screen which displays in light green.
Press COPY to start to set an area.
CH to end and enable
the area, or press PAUSE to end and
disable the area.
G to select a horizontal or
area, and press
R to switch a horizontal
cal area.
quit the motion area edit.
ACTIVE CAMERA: Displays the active camera in full screen mode
on the call monitor.
SUMMARY: Dial Jog to change items in
press SELECT to
Then press SEAR
Dial JO
a vertical
ENTE
or verti
Press MENU to
To test a motion area: Grids will turn into light red from light green
when a motion is detected.
motion area.
30