5installation, 59 / 63 fr – Beko 30 Inch Over the Range Convection Microwave Installation Guide User Manual
Page 59
Four à micro-ondes à convection à hotte intégrée / Manuel d’installation
59 / 63 FR
5
Installation
7. Serrez les deux vis extérieures qui se trouvent
sur la partie supérieure du four à micro-ondes.
(Lorsque vous serrez les vis, maintenez le
four à micro-ondes contre le mur et l’armoire
supérieure.)
8. Installez les filtres à graisse. Reportez-vous au
manuel d’utilisation qui accompagne le four à
micro-ondes.
5.2.3 Recyclage d’air (évacuation
sans conduit de type C)
3/8" TO EDGE
NOTE: IT IS VERY IMPORTANT
TO
READ AND FOLLOW THE DIREC
TIONS
IN THE INSTALLATION INSTR
UCTIONS
BEFORE PROCEEDING WITH
THIS
REAR WALL TEMPLATE.
This Rear Wall Template serves to
position the bottom
mounting plate and to locate the h
orizontal exhaust
outlet.
1. Use a level to check that the tem
plate is positioned
accurately.
2. Locate and mark at least one st
ud on the left or
right side of the centerline.
It is important to use at least one w
ood
screw mounted firmly in a stud to s
upport the weight
of the microwave. Mark two additio
nal, evenly spaced
locations for the supplied toggle b
olts.
3. Drill holes in the marked locatio
ns. Where there is
a stud, drill a 3/16" hole for wood s
crews. For holes
that do not line up with a stud, dril
l 5/8" holes for
toggle bolts.
DO NOT INSTALL THE MOUNTIN
G PLATE
AT THIS TIME.
4. Remove the template from the
rear wall.
5. Review the Installation Instructio
n book for your
installation situation.
Locate and mark holes to align
with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD
ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2
ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN
THE MOUNTING PLATE
AREA.
Locate and mark holes to align
with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STU
D ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 A
DDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN T
HE MOUNTING PLATE
AREA.
Trim the rear wall template al
ong the dotted line.
Trim the rear wall template al
ong the dotted line.
12"
4"
Darle vuelta a la hoja para cons
ultar la
versión en Español.
Vue d’ensemble de l’installation
C1. Fixation de la plaque de montage au mur
C2. Préparation de l’armoire supérieure
C3. Vérification de la plaque du ventilateur
C4. Installation du four à micro-ondes
C5. Installation ou changement du filtre à charbon
A
Assurez-vous que les vis du moteur
du ventilateur et de la plaque du
ventilateur sont correctement ser-
rées lorsque vous les remettez en
place. Cela permet d’éviter des vibra-
tions excessives.