Beko 30 Inch Over the Range Convection Microwave Installation Guide - Manual (Page 19)

19 / 63 EN Over The Range Convection Microwave Oven / Installation Manual
5 Installation
A3. Adapting microwave blower for
outside top exhaust
1. Place the microwave in its upright position, with
the top of the unit facing up. Remove the screw
that holds the blower plate to the microwave.
Remove and save the screw holding the blower
motor to the microwave.
Blower Plate
Blower Motor
Screw
Back of
Microwave
2. Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
End B
End A
Back of
Microwave
3. Roll the blower unit 90° so that fan blade
openings are facing out the top of the
microwave.
Back of
Microwave
Before Rotation After Rotation
Back of
Microwave
4. Place the blower unit back into the opening.
Back of
Microwave
AFTER: Fan Blade
Openings Facing Top
5. Secure blower unit to microwave with the screw
removed in Step 1. Make sure the screw is tight.
6. Replace blower plate with the screw removed in
Step 1. Make sure the screw is tight.
Back of
Microwave
7. Attach the exhaust adaptor to the top of the
blower plate by sliding it into the guides of
the blower plate. Push in securely until it is in
the locking tabs. Take care to assure that the
damper hinge is installed so that the damper
swings freely.
Back of
Microwave
Guide
Adaptor
Locking Tab