beautypg.com

5installation, 16 / 63 en, 4 aligning the wall plate – Beko 30 Inch Over the Range Convection Microwave Installation Guide User Manual

Page 16: Do not mount the plate at this time

background image

Over The Range Convection Microwave Oven / Installation Manual

16 / 63 EN

Area E

Hole

A

Hole

B

Centerline

notches

Draw a Vertical Line

on Wall from Center

of Top Cabinet

Draw a Horizontal line on wall from

bottom of “Rear Wall Template”.

Horizontal Line

Horizontal Line

CL

3/8" TO EDGE

NOTE: IT IS VERY IMPORTANT TO

READ AND FOLLOW THE DIRECTIONS

IN THE INSTALLATION INSTRUCTIONS

BEFORE PROCEEDING WITH THIS

REAR WALL TEMPLATE.
This Rear Wall Template serves to position the bottom

mounting plate and to locate the horizontal exhaust

outlet.

1. Use a level to check that the template is positioned

accurately.

2. Locate and mark at least one stud on the left or

right side of the centerline.

It is important to use at least one wood

screw mounted firmly in a stud to support the weight

of the microwave. Mark two additional, evenly spaced

locations for the supplied toggle bolts.

3. Drill holes in the marked locations. Where there is

a stud, drill a 3/16" hole for wood screws. For holes

that do not line up with a stud, drill 5/8" holes for

toggle bolts.

DO NOT INSTALL THE MOUNTING PLATE

AT THIS TIME.

4. Remove the template from the rear wall.

5. Review the Installation Instruction book for your

installation situation.

Locate and mark holes to align with holes in the

mounting plate.

IMPORTANT:

LOCATE AT LEAST ONE STUD ON EITHER SIDE OF

THE CENTERLINE.

MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY

SPACED TOGGLE BOLTS IN THE MOUNTING PLATE

AREA.

Locate and mark holes to align with holes in the

mounting plate.

IMPORTANT:

LOCATE AT LEAST ONE STUD ON EITHER SIDE OF

THE CENTERLINE.

MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY

SPACED TOGGLE BOLTS IN THE MOUNTING PLATE

AREA.

Trim the rear wall template along the dotted line.

12"

4"

Darle vuelta a la hoja para consultar la

versión en Español.

A

Wear gloves to avoid cutting fingers

on sharp edges.

5.1.4 Aligning the wall plate

1. Draw a Vertical line on the wall at the center of

the 30” wide space.

2. Draw a Horizontal line on the wall at the bottom

of “Rear Wall Template”.

3. Drill 5/8” holes for toggle bolts on 2 locations

(Hole A, Hole B) but if the location of hole is

same as that of stud, drill a 3/16” hole for wood

screw. In other words, toggle bolt can not be

used to the location of stud.

C

DO NOT MOUNT THE PLATE AT THIS

TIME.

5

Installation

C

Holes A and B are inside area E. If

both of A and B are not in a stud,

find a stud somewhere in area E and

draw a forth circle to line up with the

stud. It is important to use at least

one wood screw mounted firmly in

a stud to support the weight of the

microwave. Set the mounting plate

aside.

This manual is related to the following products: