Beko 30 Inch Over the Range Convection Microwave Installation Guide - Manual (Page 26)

Over The Range Convection Microwave Oven / Installation Manual 26 / 63 EN
5 Installation
8. Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Back
End A
End B
A
Do not pull or stretch the blower unit
wiring. Make sure the wires are not
pinched, and that they are properly
secured.
C
The blower unit exhaust openings
should match exhaust openings on
rear of microwave oven.
9. Secure the blower unit to the microwave with
the original screw.
Blower Plate
Blower Motor
Screw
Back of
Microwave
10. Replace the blower plate in the same position
as before with the screw. Make sure the screw
is tight
11. Attach the exhaust adaptor to the rear of
the oven by sliding it into the guides at the
top center of the back of the oven. Push in
securely until it is in the lower locking tabs.
Take care to assure that the damper hinge is
installed so that it is at the top and that the
damper swings freely.
Guide
Guide
Adaptor
Locking Tabs
Back of
Microwave
B6. Mount the microwave oven
C
For easier installation and person-
al safety, we recommend that two
people install this microwave oven.
A
Do not grip or use handle during in-
stallation.
C
If your cabinet is metal, use the ny-
lon grommet around the power cord
hole to prevent cutting of the cord.
C
We recommend using filler blocks if
the cabinet front hangs below the
cabinet bottom shelf.