Enterasys Networks Enterasys SecureStack A2 A2H124-48P User Manual
Page 53
Installing Optional Mini-GBICs
SecureStack A2 PoE Installation Guide 3-23
Preparation
Before installing the Mini‐GBIC, proceed as follows:
1.
Before removing the Mini‐GBIC from the antistatic packaging, it is recommended that
you use an antistatic wrist strap (not supplied) to prevent damage from static
discharge. To use the wrist strap, refer to the instructions provided with your
antistatic wrist strap.
2.
Remove the Mini‐GBIC from its packaging.
3.
If there is a protective dust cover in the Mini‐GBIC connector, do not remove it at this
time.
Installation
To install a Mini‐GBIC that has an MT‐RJ connector, refer to
; for a Mini‐GBIC
with an LC connector, refer to
; for a Mini‐GBIC with an RJ45 connector, refer
to
; and proceed as follows:
1.
Hold the Mini‐GBIC with the top side positioned as shown, and the 7‐pin edge
connector facing the port slot.
2.
Align the Mini‐GBIC with the port slot.
3.
If you are using the RJ45 Mini‐GBIC as in
, be sure the release tab is in the
up position.
4.
Push the Mini‐GBIC into the port slot until the Mini‐GBIC “clicks” and locks into
place.
Caution: Carefully follow the instructions in this manual to avoid damaging the
Mini-GBIC and the device.
The Mini-GBIC and the device are sensitive to static discharges. Use an antistatic wrist
strap and observe all static precautions during this procedure. Failure to do so could result
in damage to the Mini-GBIC or the switch. Always leave the Mini-GBIC in the antistatic bag
or an equivalent antistatic container when not installed.
Precaución: Siga las instrucciones del manual para no dañar el Mini-GBIC ni del aparato,
puesto que son muy sensible a las descargas de electricidad estática. Utilice la pulsera
antiestática y tome todas las precauciones necesarias durante este procedimiento. Si no
lo hace, podría dañar el Mini-GBIC o del aparato. Mientras no esté instalado, mantenga el
Mini-GBIC en su bolsa antiestática o en cualquier otro recipiente antiestático.