Guidelines for flat surface installation, Guidelines for flat surface installation -5, Аб г в – Enterasys Networks Enterasys SecureStack A2 A2H124-48P User Manual
Page 35
Installing the Switch on a Flat Surface
SecureStack A2 PoE Installation Guide 3-5
Guidelines for Flat Surface Installation
Locate the switch within 152 cm (5 ft) of its power source and on a surface as shown in
. If an optional redundant power system is going to be installed and connected
to the 14‐pin Redundant Power Supply input connector on the rear of the switch,
refer to
the installation guide shipped with the redundant power system.
If you are installing several switches in a stack, proceed to “
on page 3‐7. If the switch is being installed as a standalone switch, proceed to “
” on page 3‐12 for power connection instructions.
Figure 3-2 Area Guidelines for Switch Installation on Flat Surface
Caution: To ensure proper ventilation and prevent overheating, leave a minimum
clearance space of 5.1 cm (2.0 in.) at the left, right, and rear of the switch.
Do not connect the switch to the AC power source until instructed to do so later in the
installation process.
Precaución: Para asegurar una buena ventilación y evitar que el sistema se
sobrecaliente, deje un espacio mínimo de 5.1 cm (2 pulgadas) con respecto a los lados y
a la parte posterior del aparato.
No conecte el dipositivo a la fuente primaria hasta que no se le indique.
1 Approximately 152 cm (5 ft) from power source
3 44.5 cm (19.4 in.) for proper ventilation
2 4.45 cm (1.75 in.) per switch. (Vertical clearance
depends on number of switches stacked.)
4 41.9 cm (16.5 in.) for proper ventilation
А
Б
Г
В
1
2
11
12
13
14
23
24
Console
25
26
27
28
25/Up
26/Down
Stack
27
28
1
3
5
7
9
11 13 15 17 19 21 23
2
4
6
8
10 12 14 16 18 20 22 24
CPU
RPS
MGR
A2H124-24
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24