Network requirements, 10base-t network, Chapter 2: network requirements – Enterasys Networks Enterasys SecureStack A2 A2H124-48P User Manual
Page 29: 10base-t network -1, Hapter 2
SecureStack A2 PoE Installation Guide 2-1
2
Network Requirements
Before installing the device, review the requirements and specifications in this chapter
concerning the following:
10BASE-T Network
When connecting a 10BASE‐TX segment to one of the RJ45 fixed ports (1 through 24 on
A2H124‐24P, 1 through 48 on A2H124‐48P), ensure that the network meets the Ethernet
network requirements of the IEEE 802.3‐2002 standard for 10BASE‐TX. Refer to the
Cabling Guide for details.
For information about...
Refer to page...
Note: The network installation must meet the requirements described in this chapter to
ensure satisfactory performance of this equipment. Failure to do so will produce poor
network performance.
Note: The SecureStack A2 Configuration Guide and the Cabling Guide referred to in the
following sections can be found on the Enterasys Networks World Wide Web site:
For details about obtaining the manuals, refer to “
Note: If an RJ45 port is to operate at 100 Mbps, Category 5 cabling must be used.
Category 3 cabling does not meet the 100 Mbps specifications. Refer to
(page 2-2) for information about 100BASE-TX networks and cabling.