Canon imagePROGRAF GP-300 - Manual (Page 357)

Firmware update
Important
• When you use this function, make sure the printer is connected to the Internet.
• The administrator password is required to change settings if it is enabled for changing settings using the
operation panel.
Using Operation Panel
1. Tap ( Setup ) on HOME screen. 1.
Home Screen Menu Composition
2. Tap Printer settings . 2.
3. Tap Firmware update . 3.
If an administrator password is set, enter the password.
4. Tap Install update . 4.
5. Tap Yes . 5.
6. Confirm displayed message and tap Start update . 6.
Using Remote UI
1. Start up Remote UI. 1.
Start up Remote UI
2. Select Firmware update . 2.
3. Select Install update . 3.
4. Confirm displayed message and select Update . 4.
Note
• If the firmware update is not complete, check the following and take an appropriate action. •
Check the network settings such as a wireless router.
If Cannot connect to the server. is displayed on the touch screen, select OK and try again
after a while.
357