Canon imagePROGRAF GP-300 - Manual (Page 168)

◦ Enable/disable Wi-Fi ◦
Select Enable to wirelessly connect via wireless router.
◦ Wi-Fi setup ◦
Select how to setup Wi-Fi.
▪ Easy wireless connect ▪
Select if you specify the settings of the access point information to the printer directly from a
device (e.g. smartphone, or tablet) without operating the wireless router. Follow the on-screen
instructions of the connecting device for the setup procedure.
▪ Manual connect ▪
Select when you perform settings for Wi-Fi manually using the operation panel of the printer.
▪ WPS (Push button method) ▪
Select when you perform settings for Wi-Fi using a wireless router supporting a Wi-Fi Protected
Setup (WPS) push button method. Follow the on-screen instructions during setup.
▪ Other connection types ▪
▪ Manual connect (adv.) ▪
Select when you perform settings for Wi-Fi manually. You can specify multiple WEP keys.
▪ WPS (PIN code method) ▪
Select when you perform settings for Wi-Fi using a wireless router supporting a Wi-Fi
Protected Setup (WPS) PIN code method. Follow the on-screen instructions during setup.
Note
• By tapping Advanced , you can set LAN in detail. •
For the items that can be set, see the following.
Advanced
• Wireless Direct •
The following setting information on the Wireless Direct connection is displayed. (Some items are not
displayed depending on printer settings.)
Items Setting
Connection Enable / Disable
Network name (SSID) DIRECT-XXXX-GP-NNNN*1
Password XXXXXXXXXX (10 characters)
Communication mode Wireless Direct
Channel 3
Wi-Fi security WPA2-PSK (AES)
IPv4 address XXX. XXX. XXX. XXX (12 characters)
IPv4 subnet mask XXX. XXX. XXX. XXX (12 characters)
IPv4 default gateway XXX. XXX. XXX. XXX (12 characters)
168