Power supply, Using ac power (dc in power), P33 [using ac power (dc in power)] ) – JVC GY-HC900STU 2/3" HD Connected Cam Studio Camcorder (Body Only) User Manual
Page 33
Power Supply
To use this camera recorder, you can attach a
battery pack or connect an AC adapter to it.
P33 [Using AC Power (DC IN Power)] )
Caution :
0
Set the [POWER ON/OFF] switch to “OFF”
before changing the power supply that operates
this camera recorder.
0
Use the camera recorder and peripheral
equipments within the rated output of the AC
adapter.
0
To connect other peripheral equipment, do so
under the following conditions.
0
Keep the total power consumption of the
peripheral equipments under 35 W when
using the recommended battery.
0
Keep the total power consumption of the
peripheral equipments under 65 W when
using Tandem 150 (recommended AC
adapter).
u
w
0
Keep the total power consumption of the
peripheral equipments under 50 W when
using AC-100 (recommended AC adapter).
x
0
The power consumption of the [LIGHT] terminal
is below 50 W. Keep the total power
consumption of the peripheral equipments
excluding the [LIGHT] terminal under 35 W
when using the terminal. If the total power
consumption of the peripheral equipments
exceeds the rating, the power to the [LIGHT],
[DC OUT] (rear) and [DC OUT] (LAN) terminals
is automatically cut off. This is not a malfunction.
Use peripheral equipments with lower power
consumption then turn on the power of this
camera recorder again.
u
w
x
0
To check the power consumption, refer to the
Power screen of the Status screen.
0
If the voltage of the [DC INPUT] becomes 12 V
or less, the USB adapter connected to the
[HOST] terminal cannot be used. Check the
power supply and the peripheral equipments,
and turn on the power of this camera recorder
again.
0
Use a power supply of 12 V/ 2A or below for the
[LIGHT] terminal.
The [LIGHT] terminal, DC OUT terminal
(rear)/DC OUT (LAN) terminal and the D-tap
terminal of the battery loading folder cannot be
used at the same time.
v
Using AC Power (DC IN Power)
Use the AC adapter (sold separately) to operate
the camera recorder with AC power.
Recommended AC Adapter
u
w
: Tandem 150 (Anton/Bauer)
v
: IA-300a (IDX)
x
: AC-100 (IDX)
Memo :
0
For the type of AC adapter to be attached on a
battery mount, check the method of attachment
o
Attaching Core Filter Beforehand
v
Attach the core filter (large) to the DC cable of the
AC adapter before using the AC adapter.
.
Release the
stopper.
To be connected to the AC Adapter.
5 cm
Wind twice
1
Connect the DC cable of the AC adapter to
the [DC INPUT] terminal of the camera
recorder.
Check that the power of this unit and that of the
AC adapter are both set to “OFF”, followed by
connecting according to the diagram.
.
2
Turn on the power of the AC adapter,
followed by setting the [POWER ON/OFF]
switch of this unit to “ON”.
Power will be supplied to the camera recorder.
Caution :
0
Do not insert or remove the DC cable during
recording.
0
Do not use power supply of high voltage
fluctuation, containing noise such as ripple, or
with insufficient capacity.
Power Supply
33
Pr
ep
ar
ati
ons