Dell 23.8" OptiPlex 7410 All-in-One Desktop Computer (Gray) User Manual

Page 60

Steps

1. Align the notch on the M.2 2230 solid-state drive with the tab on the solid-state drive slot (M.2 PCIe SSD 1).
2. Slide the M.2 2230 solid-state drive into the solid-state drive slot (M.2 PCIe SSD 1) on the system board.
3. Replace the screw (M2x3.5) that secures the M.2 2230 solid-state drive to the system board.

Next steps

1. Install the

2. Install the

3. Install the

4. Install the

5. Follow the procedure in

After working inside your computer

Removing the M.2 2280 solid-state drive in M.2 slot 1

Prerequisites

1. Follow the procedure in

Before working inside your computer

2. Remove the

3. Remove the

4. Remove the

5. Remove the

About this task

NOTE:

Depending on the configuration ordered, your computer may have up to two M.2 2230 or 2280 solid-state drives

installed in the solid-state drive slots on the system board.

NOTE:

This procedure is applicable for computers where an M.2 2280 solid-state drive is installed in the solid-state drive

slot (M.2 PCIe SSD 1) on the system board.

The following image(s) indicate the location of the M.2 2280 solid-state drive in M.2 slot 1 and provides a visual representation
of the removal procedure.

Removing and installing Customer Replaceable Units (CRUs)