Dell 23.8" OptiPlex 7410 All-in-One Desktop Computer (Gray) - Manual (Page 49)

5. Align the screw holes on the graphics card with the screw holes on the graphics-card assembly.
6. Loosen the four captive screws that secure the graphics card to the graphics-card assembly.
7. Replace the two screws (M2.5x5) that secure the graphics card to the graphics-card assembly.
8. Flip over the graphics-card assembly.
9. Connect the graphics-card fan to the graphics card.
10. Close the DGFX door and press it into place, securing it.
11. Place the graphics-card assembly on the display-assembly base and slide the graphics card into the PCIe x16 connector
(SLOT1 PCIe4 x4) on the system board.
12. Replace the two screws (M3x5) that secure the graphics-card assembly to the display-assembly base.
Next steps
1. Install the back cover .
2. Install the stand .
3. Follow the procedure in After working inside your computer .
System-board shield
Removing the system-board shield
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the stand .
3. Remove the back cover .
About this task
The following image(s) indicate the location of the system-board shield and provides a visual representation of the removal
procedure.
Removing and installing Customer Replaceable Units (CRUs) 49