Dell 23.8" OptiPlex 7410 All-in-One Desktop Computer (Gray) User Manual
Page 55
About this task
NOTE:
This procedure is only applicable if you are installing an M.2 2230 solid-state drive into the solid-state drive slot (M.2
PCIe SSD 0) on the system board.
NOTE:
Ensure that the M.2 screw mount is in the proper location to install the M.2 2230 solid-state drive, refer to
of the screw mount on M.2 slot 0
.
The following image(s) indicate the location of the M.2 2230 solid-state drive in M.2 slot 0 and provides a visual representation
of the installation procedure.
Steps
1. Align the notch on the M.2 2230 solid-state drive with the tab on the solid-state drive slot (M.2 PCIe SSD 0).
2. Slide the M.2 2230 solid-state drive into the solid-state drive slot (M.2 PCIe SSD 0) on the system board.
3. Replace the screw (M2x3.5) that secures the M.2 2230 solid-state drive to the system board.
Next steps
1. Install the
2. Install the
.
3. Install the
.
4. Follow the procedure in
After working inside your computer
.
Removing the M.2 2280 solid-state drive in M.2 slot 0
Prerequisites
1. Follow the procedure in
Before working inside your computer
.
.
About this task
NOTE:
Depending on the configuration ordered, your computer may have up to two M.2 2230 or 2280 solid-state drives
installed in the solid-state drive slots on the system board.
Removing and installing Customer Replaceable Units (CRUs)
55