Installing the memory – Dell 23.8" OptiPlex 7410 All-in-One Desktop Computer (Gray) User Manual

Page 43

Text mode
Original mode

Steps

1. Using the tab on the DIMM door, pry open and lift the DIMM door on the system-board shield to access the memory slots.
2. Using your fingertips, carefully spread apart the securing clips on each end of the memory-module slot until the memory

module pops out.

3. Remove the memory module from the memory-module slot.

NOTE:

Repeat steps 2 to 3 for each memory module installed on your computer.

Installing the memory

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the memory and provides a visual representation of the installation procedure.

Removing and installing Customer Replaceable Units (CRUs)