Epson Y465ss127mo - Manual (Page 94)

Setting the Loading Position
The loading position is the position of the paper when it has been
automatically loaded by the printer.
The loading position is important because it determines where the
printing begins on each page. If the printing is too high or too low on the
page, change the loading position using the micro-adjustment feature
described below.
Separate loading positions can be set for single sheets, continuous paper,
and sheets loaded by the cut sheet feeder.
WARNING: Never use the platen knob for feeding except
in the case of a paper jam or other paper feed problem.
Using the platen knob while the printer is on results in an
error message 12 ). To clear this error, you must
turn off the printer, remove the paper, turn the printer
back on, and reload the paper with the LOAD/EJECT button.
To adjust the loading position always use the micro-
adjustment feature.
Until this loading position is reset, the printer remembers this loading
position and uses it as a reference point for feeding the paper.
The micro-adjustment feature moves the paper l/180th of an inch at a
time to make fine adjustments of the loading position. Once you have
used micro-adjustment to change the loading position of continuous
paper, the printer remembers that position even after you turn off or
initialize the printer. However, the printer does not remember the loading
position for friction or cut sheet feeder mode.
Adjusting the loading position
To adjust the loading position, follow these steps:
1. Load your paper.
2. Press the MICRO FEED button to select the micro-feed mode. The
MICRO FEED light comes on and the display shows
stands for top of form.)
3-30 Using the Printer