Epson Y465ss127mo - Manual (Page 246)

CHASSIS GND
32 ERROR
33 GND
34 NC
35
s LOW, the printer
controller is reset to its power-up state
and the print buffer is cleared. This level
is usually HIGH; its pulse width must be
more than 50 microseconds at the
receiving terminal.
OUT level becomes LOW when the printer
1) in paper-out state
2) off line
3) in error state.
Same as for Pins 19 30.
Not used.
OUT Pulled up to 5V through ohm
resistance.
36 SLCT IN
The code is valid only when this
signal is “HIGH”. he same effect can
be achieved with
l
The column heading “Direction” refers to the direction of signal flow
as viewed from the printer.
“Return” denotes the twisted-pair return, to be connected at signal
ground level. For the interface wiring, be sure to use a twisted-pair
cable for each signal and to complete the connection on the return
side. These cables should be shielded and connected to the chassis of
the host computer and the printer.
A-10 Technical Specifications