Epson Y465ss127mo - Manual (Page 83)

PARITY * Ignore
Disable, Enable
*Displayed only when the serial interface setting is selected
The LQ-2550 comes with preset default values, which can be printed out
using the PRINT SETTINGS mode. These default values are shown
below.
D e f a u l t ,
INTERFACE P a r a l l e l
RATE * 9 6 0 0 R P S
PARITY
*
None
AUTO FEED O f f
D i s a b l e
MACRO
If your computer has a parallel interface, the preset defaults should work
correctly in most cases. You may wish to change the DEFAULT MACRO
settings, however, to match your usual style of printing. Here are a few
additional tips on setting the defaults.
l
If your computer has a serial interface, you need to
change the interface setting to Serial. (If you are using an optional
interface board, be sure that the interface setting is Pa a 11 e 1,
regardless of what type of interface it actually is. See the section on
interface boards in Chapter for more information.)
l
Set these only if you are using the serial
interface. (Be sure to first set the interface setting to Serial .
and PARITY do not display in SelecType unless the interface is
set to Se i a 1.) Check your computer manual for the correct baud
rate and parity settings. Your computer and printer should be set to
the same baud rate and parity.
Using the Printer 3-19