Epson Y465ss127mo - Manual (Page 108)

Using word processors
Word processors usually let you use a fixed set of printer features by
placing markers around the text to be altered. When the document is
printed, the markers are recognized and translated into suitable
commands for your printer. On your screen some programs show the
markers; others display the text as it will appear-for example, in bold
or italics. This method is normally restricted to features that can be
found on almost all printers, such as bold and underlining.
Some word processing programs also let you insert printer commands in
your text. These commands may or may not be visible on your screen.
This method has the advantage of allowing you to use any printer
command, not just a limited set. To make use of it, however, you need to
understand how to use your printer’s commands. Check the manual for
your word processor to see if you can place printer commands in your
text, and then see the section in this chapter on computer-printer
communications.
Using spreadsheets
Although spreadsheets seldom use as many printing styles as word
processors, they do have some very specific requirements.
If your spreadsheet program provides a list of printers, use the list on
page 4-2 to find the proper selection. If your spreadsheet doesn’t have a
printer setup routine, read the program’s manual carefully for
information on printing.
A major concern for printing spreadsheets is the width of the printer. The
LQ-2550 is a 136-column printer. You can, however, increase the number
of characters on a line by selecting 12 cpi, condensed mode, or both from
the SelecType control panel. The table below shows you many
characters you can fit on a line using these options. If your spreadsheet
asks the number of columns your printer can print, decide which mode
you will use and supply the appropriate number from this table.
Using Software and Graphics 4-3