Adjustments – Epson Universal Projector Mount with 3" Extension Column User Manual
Page 11
Installation Instructions
ELPMBPJG
11
ADJUSTMENTS
YAW Adjustment
1.
Loosen yaw adjustment screw using the 5/32" hex key. (See
Figure 19)
NOTE:
Yaw is only adjustable when attached to a threaded
pipe.
WARNING:
Do not turn the projector to the end of the pipe
threads. The projector, universal interface and projector
mount will fall from the pipe if it is unthreaded too far! A
minimum of four threads MUST be engaged in order to
ensure a secure connection!
2.
Adjust projector by turning the projector on the pipe to the
desired yaw position.
3.
Tighten yaw adjustment locking screw using the 5/32" hex
key.
Figure 19
Pitch Adjustment
4.
Loosen pitch adjustment locking screw on each end of the
RSA projector mount using a #2 Phillips screwdriver.
5.
Adjust projector angle to desired pitch. (See Figure 20)
6.
Tighten pitch adjustment locking screw on each end of the
RSA projector mount using a #2 Phillips screwdriver.
Figure 20
Roll Adjustment
7.
Loosen roll adjustment locking screw on each side of the
RSA projector mount using a #2 Phillips screwdriver.
8.
Adjust projector to desired roll position. (See Figure 21)
9.
Tighten roll adjustment locking screw on each side of the
RSA projector mount using a #2 Phillips screwdriver.
Figure 21
1
3
2
4
6
5
7
9
8