Epson BrightLink 1485Fi 5000-Lumen Pixel-Shift Full HD Ultra-Short Throw 3LCD Interactive Laser Projector User Manual
Page 361
361
Solutions When the Interactive Pens Are Slow or Difficult to Use
If the pens are difficult to use or respond too slowly, try the following solutions:
• For easier operation, hold the pen perpendicular to the projection surface.
• For the best performance, connect your computer to the projector using a VGA or HDMI cable for
display and the USB cable for interactivity.
• If you are using USB Display in Windows, you may need to disable Windows Aero in the Epson USB
Display Settings program on your computer.
• If you are having difficulty double-clicking on a Mac, go to the
System Preferences
menu, select
Mouse
,
Trackpad
, or
Mouse & Trackpad
, and reduce the
Double-click speed
.
• Set the
Pen/Touch
>
Pen Hovering
setting to
Off
.
Parent topic:
Related references
Pen and Touch Setup Settings - Pen/Touch Menu
Related tasks
Solutions When the Interactive Pens Cause Interference or Unwanted Effects
If the pens are causing interference or unwanted effects, try the following solutions:
• When you use two pens at the same time, make sure to use them at least 4 inches (10.16 cm) apart.
• Do not rest the pens on the image area of an interactive table to avoid interference with your
computer's mouse.
• Make sure that nothing is blocking the direct line to the interactive pen receiver on the projector.
Parent topic:
Solutions When Finger Touch Interactivity Does Not Work
If finger touch interactivity does not work, try the following solutions:
• Make sure a Touch Unit is installed correctly and the cable is properly connected. See your projector's
online
Installation Guide
for details.
• If the light on the Touch Unit is not on, check the
Touch Unit
settings in the Pen/Touch menu and
make sure the
Power
setting is set to
On
.
• Make sure touch interactivity is activated on the toolbar.