Roland DJ-505 2-Channel, 4-Deck DJ Controller for Serato DJ - Manual (Page 16)

16
Operating the DJ-505
Effect Operations
Serato DJ has two effect units (FX1, FX2) which you can use with the
selected deck.
DJ-FX panel
When you click “FX” in the upper left of Serato DJ’s main screen, the DJ-FX
panel opens.
Multi FX mode
You can select up to three effects for each effect unit.
1 1 1 2 3
4 5 4 5 4 5
Single FX mode
You can select one effect for each effect unit, and control multiple
parameters of the selected effect.
1 2 3
4 5 6 6 6 6
1
Currently selected effect type
2
Time at which the effect is applied
3
Number of the deck that uses the effect unit is highlighted
4
Effect on/off status (highlighted when on)
5
Effect depth
6
Effect parameters and settings
Multi FX Mode Operations
1 Hold down the [SHIFT] button and press the [TAP] button to
select multi FX mode.
Each time you press the button, you alternate between multi FX mode
and single FX mode.
2 In the CHANNEL ASSIGN area of the deck (channel) that you
want to operate, press the [1] or [2] button to select the effect
unit that you want to use.
In the DJ-FX panel of the Serato DJ screen, the number of the deck that
uses the effect unit is highlighted.
MEMO
By pressing the [TR/SAMPLER] button you can apply an effect to the
TR-S/sampler sound.
* In Serato DJ’s Sampler panel, set OUTPUT to “A.”
3 Hold down the [SHIFT] button and press an effect button to
select the effect type.
The effect type changes each time you press the button.
4 Press the effect button to turn the effect on (button lit).
5 Use the effect parameter knobs to adjust the effect depth.
6 Use the [BEATS] knob to adjust the time at which the effect is
applied.
* If you press the knob, the setting is set to “1.”
MEMO
By tapping the [TAP] button at the desired interval, you can set the
value that is the basis for the time at which the effect is applied.
Single FX Mode Operations
1 Hold down the [SHIFT] button and press the [TAP] button to
select single FX mode.
Each time you press the button, you alternate between single FX mode
and multi FX mode.
2 Press the [1] or [2] button of the deck (channel) that you want
to operate, to select the effect unit that will be used.
In the DJ-FX panel of the Serato DJ screen, the number of the deck that
uses the effect unit is highlighted.
MEMO
By pressing the [TR/SAMPLER] button you can apply an effect to the
TR-S/sampler sound.
* In Serato DJ’s Sampler panel, set OUTPUT to “A.”
3 Hold down the [SHIFT] button and press the effect 1 button to
select the effect type.
It does not matter which effect button you press.
The effect type changes each time you press the button.
4 Press the effect 1 button to turn the effect on (button lit).
5 Press the effect 2 or 3 button to switch the value of the effect
parameters.
6 Use the effect parameter 2 or 3 knobs to adjust the value of the
effect parameters.