Roland FP-E50 88-Key Portable Digital Piano - Manual (Page 64)

Editing a Scene (Scene Edit)
64 64
Assigning Functions to the Pedals
(Pedal Setting)
You can assign the functions you want to control to pedals 1 and 2.
1.
On the Scene Edit screen, use the [ дд ] [ ее ] buttons to
select “Pedal Setting” and press the [Enter] button .
The Pedal Setting screen appears.
2. Use the [ дд ] [ ее ] buttons to select the parameter, and
then use the [Dec] [Inc] buttons to change the value .
Parameter Value Explanation
Pedal 1
Function
This assigns the functions to Pedal 1.
Damper (*1)
Damper pedal
Sostenuto (*1) Sostenuto pedal
Soft (*1)
Soft pedal
Layer
Controls the layer volume in Dual
mode.
Expression (*1) Controls the expression.
Master
Expression
Controls the volume of the
instrument overall.
Mic FX Sw
Works the same as the [Mic FX]
button.
Bass
Inversion1
Switches Bass Inversion on/off.
Bass
Inversion2
Turns Bass Inversion on, but only
when the pedal is pressed.
Arranger Hold Switches Arranger Hold on/off.
Variation 1/2
Switches between variation 1/2.
Variation 1
Works the same as the [Variation 1]
button.
Variation 2
Works the same as the [Variation 2]
button.
Intro/Ending
Works the same as the [Intro/
Ending] button.
Start/Stop Starts and stops the style.
Play/Stop Plays back and stops the song.
Rotary Speed Switches between rotary speeds.
Modulation
(*1, *2)
Controls the modulation depth.
Bend Up
(*1, *2)
Controls the pitch bend up.
Bend Down
(*1, *2)
Controls the pitch bend down.
Pedal 1
Part
This sets the parts controlled by Pedal 1.
Right & Left
Upper part and lower part
Right Upper part only
Left Lower part only
Pedal 2-R
Function
This assigns the functions to Pedal 2-R.
(Same as the Pedal 1 Function parameter)
Parameter Value Explanation
Pedal 2-R
Part
This sets the parts controlled by Pedal 2-R.
(Same as the Pedal 1 Part parameter)
Pedal 2-C
Function
This assigns the functions to Pedal 2-C.
(Same as the Pedal 1 Part parameter)
Pedal 2-C
Part
This sets the parts controlled by Pedal 2-C.
(Same as the Pedal 1 Part parameter)
Pedal 2-L
Function
This assigns the functions to Pedal 2-L.
(Same as the Pedal 1 Part parameter)
Pedal 2-L
Part
This sets the parts controlled by Pedal 2-L.
(Same as the Pedal 1 Part parameter)
* 1 The effects are applied to the tone that’s set for the Pedal Part .
* 2 Note that some effects might not be applied even if you set them, depending on the
tone .
3.
If you want to save the edited settings, execute the
Write operation .
Ø “Saving a Scene (Scene Write)” (p. 27)
MEMO
If you switch to a different scene, or turn off the power after editing the
settings, the edited settings are lost . If you want to keep the data, you
must save it .