ProSoft Technology RLX2-IFH9E - Manual (Page 91)

ControlScape ♦ RadioLinx Dialog Boxes
RadioLinx® ControlScape FH User Manual
ProSoft Technology, Inc. Page 91 of 132
March 16, 2011
Collision Handling: Select (check) this checkbox to turn on collision
handling. All radios in the network should be set the same, either on or off.
Collision Handling is not necessary for:
o
A single point to point device network
o
A single master slave device network
o
Any other situation where normally only one device is transmitting at a
time
Collision Handling may be necessary if:
o
Multiple independent device networks are connected to a single radio
network
o
The devices use a peer-to-peer asynchronous protocol
o
Any other situation where multiple devices are regularly transmitting
simultaneously
Configure Via COM Port: Select (check) this checkbox to use a connection
between the serial port on the configuration PC and the serial port on the
radio, rather than an Ethernet connection, to configure the radio.