ProSoft Technology RLX2-IFH9E User Manual
Page 82
Dialog Boxes
ControlScape ♦ RadioLinx
User Manual
RadioLinx® ControlScape FH
Page 82 of 132
ProSoft Technology, Inc.
March 16, 2011
Advanced Settings
Radio Address: The software assigns a unique address to each radio in the
network after the radio is configured (The user cannot change this addressing
scheme - the address field is grayed-out).
Network Type: This is the network type configured on the Network
Properties dialog box.
Transmit Power: This setting controls the output power in dBm (mW) to use.
You should ordinarily choose the minimum value that will maintain an
adequate system fade margin.
Important: Maximum output power for radios is controlled by regulatory agencies in the country in
which this radio will be operated. Do not choose a power level that exceeds the maximum allowed
for your country or region.
Retry Limit: When the Send Data To field is set to Broadcast, this field
specifies the number of times each RF transmission is sent for every packet.
When the Send Data To field is set to a specific radio ID, this value specifies
how many times radio packet should be retransmitted if it doesn't get through.