ProSoft Technology 5201-DFNT-DNPM - Manual (Page 22)

DNPM ♦ ProLinx Gateway DNPM Protocol Configuration
DNP 3.0 Master Driver Manual
Page 22 of 56
ProSoft Technology, Inc.
September 30, 2009
Example 1 – Digital Output
No CROB Control - Does not allow full control of Control Operation, Queue,
Clear, Trip/Close, and Pulse count. Only Latch On/Off supported and count is set
1, on and off time set to zero, 1 and status set to zero.
1
2
3 12
4
5
6
7
8
9 Low byte of parameter value is used as Poll Interval
Example 2 – Digital Output
For Select (and implied operate).
With CROB control - Allows full control of Control Operation, Queue, Clear,
Trip/Close and Pulse count.
1
2
3 -12
4 Lo byte of parameter value is object variation
5 3, [4]
6
7
8
9 Low byte of parameter value is used as Poll Interval
Example 3 – Digital Output
For Direct Operate (with/without rack).
With CROB control - Allows full control of Control Operation, Queue, Clear,
Trip/Close, and Pulse/count.
1
2
3 -12
4 Low byte is object variation. High byte = Pulse count = 1
5 Low byte = Function (5 or 6)
6
7
8
9 Not used.