ProSoft Technology 5201-DFNT-DNPM - Manual (Page 11)

Port Physical and Protocol Specifications DNPM ♦ ProLinx Gateway
Driver Manual DNP 3.0 Master
ProSoft Technology, Inc.
Page 11 of 56
September 30, 2009
2 Port Physical and Protocol Specifications
In This Chapter
™ DNP 3.0 Master Port Specifications ...................................................... 11
™ Serial Port Specifications.......................................................................11
2.1 DNP 3.0 Master Port Specifications
Type Specifications
General Parameters
Internal Database Binary Inputs: 0 to 500 word count
Analog Inputs: 0 to 500 points of analog input data
Counters: 0 to 250 points of counter data
Binary Outputs: 0 to 500 word count
Analog Outputs: 0 to 500 points of analog output
Communication parameters Port 0: Baud Rate: 110 to 115,200 baud
Stop Bits: 1
Data Size: 8 bits
Parity: None
RTS Timing delays: 0 to 65535 milliseconds
DNP Mode DNP 3.0 Master - Level 2
DNP Object Support See Reference chapter for full Object Definition document
DNP Master
Node address 0 to 65534 (software selectable)
Slave count The module supports the definition of up to 40 slave devices
Command count The module supports the definition of up to 300 user defined
commands to interface with remote slave devices
2.2 Serial Port Specifications
Type Specifications
Serial Ports
Serial Port Cables (DB-9M
Connector) One DIN to DB-9M cable included per configurable serial port
Port 0 RS-232/422/485: jumper selectable
DB-9M connector
Hardware Handshaking: RTS,CTS,DTR,DSR,DCD