ProSoft Technology 5201-DFNT-DNPM - Manual (Page 19)

DNPM Protocol Configuration DNPM ♦ ProLinx Gateway
Driver Manual DNP 3.0 Master
ProSoft Technology, Inc.
Page 19 of 56
September 30, 2009
Note: CROB commands (object 12) exceeding a count of 16 are not recommended. Many IEDs
only support one transport layer and a count > 16 may cause the IED device to not accept the new
data value being written by the ProLinx module.
The following table aids in defining the command list as it displays the values
required for certain DNP data types:
Digital input Digital input Events Digital Output Counter
0 Port/Flags Port/Flags Port/Flags Port/Flags
1 Slave Address Slave Address Slave Address Slave Address
2 1 2 12 20
3 0, 1 or 2 0, 1, 2 or 3 1* 0, 5 or 6
4 1* 1* 3, [4], 5 or 6 1, 7, 8, 9 or 10
5 Address in Slave Address in Slave Address in Slave Address in Slave
6 # of Points # of Points # of Points # of Points
7 IED DB Address IED DB Address IED DB Address
8 Poll Interval Poll Interval Poll Interval Poll Interval
Frozen Counter Analog Input Analog Input Events Analog Output
0 Port/Flags Port/Flags Port/Flags Port/Flags
1 Slave Address Slave Address Slave Address Slave Address
2 21 30 32 41
3 0, 9 or 10 0, 1, 2, 3 or 4 0, 1, 2, 3 or 4 2*
4 1* 1* 1* 3, [4], 5 or 6
5 Address in Slave Address in Slave Address in Slave Address in Slave
6 # of Points # of Points # of Points # of Points
7 IED DB Address IED DB Address IED DB Address
8 Poll Interval Poll Interval Poll Interval Poll Interval
Time and Date Class 0 Class 1 Class 2
0 Port/Flags Port/Flags Port/Flags Port/Flags
1 Slave Address Slave Address Slave Address Slave Address
2 50 60 60 60
3 1* 1 2 3
4 2*
5
6 1 1 1 1
7
8 Poll Interval Poll Interval Poll Interval Poll Interval