ProSoft Technology MVI56E-MNETR - Manual (Page 89)

Diagnostics and Troubleshooting MVI56E-MNETR ♦ ControlLogix Platform
User Manual Modbus TCP/IP Interface Module with Reduced Data Block
ProSoft Technology, Inc.
Page 89 of 153
August 31, 2009
3 If PCB is still unable to connect to the module, click the B ROWSE D EVICE ( S )
button to open the P RO S OFT D ISCOVERY S ERVICE . Select the module, then
right click and choose S ELECT FOR PCB.
Close ProSoft Discovery Service, and click the C ONNECT button again.
4 If all of these troubleshooting steps fail, verify that the Ethernet cable is
connected properly between your computer and the module, either through a
hub or switch (using the grey cable) or directly between your computer and
the module (using the red cable).
If you are still not able to establish a connection, contact ProSoft Technology for
assistance.
4.3 Monitoring Module Information
Use the M ODULE menu to view configuration and hardware information for the
MVI56E-MNETR module’s backplane and Ethernet application port.
4.3.1 Version
Use the V ERSION menu to view module hardware and firmware information.
The values on this menu correspond with the contents of the module’s
Miscellaneous Status registers.