ProSoft Technology MVI56E-MNETR - Manual (Page 22)

MVI56E-MNETR ♦ ControlLogix Platform Start Here
Modbus TCP/IP Interface Module with Reduced Data Block User Manual
Page 22 of 153
ProSoft Technology, Inc.
August 31, 2009
2 Click CIP P ATH E DIT to open the CIP CONNECT P ATH E DITOR dialog box.
The CIP CONNECT P ATH E DITOR allows you to define the path between the PC
and the MVI56E-MNETR module. The first connection from the PC is always a
1756-ENBT (Ethernet/IP) module.
Each row corresponds to a physical rack in the CIP path.
ƒ If the MVI56E-MNETR module is located in the same rack as the first 1756-
ENBT module, select R ACK N O . 1 and configure the associated parameters.
ƒ If the MVI56E-MNETR is available in a remote rack (accessible through
ControlNet or Ethernet/IP), include all racks (by using the A DD R ACK button).
Parameter Description
Source Module Source module type. This field is automatically selected
depending on the destination module of the last rack (1756-
CNB or 1756-ENBT).
Source Module IP Address IP address of the source module (only applicable for 1756-
ENBT)
Source Module Node Address Node address of the source module (only applicable for 1756-
CNB)
Destination Module Select the destination module associated to the source module
in the rack. The connection between the source and destination
modules is performed through the backplane.
Destination Module Slot Number The slot number where the destination MVI56E module is
located.