PLANET WDRT-1200AC - Manual (Page 50)

User Manual of WDRT-1200AC
-44-
 SSID:
Set a name (SSID) for your wireless network. The ID of the wireless
network. User can access the wireless network through it only.
However, if you switch to Client Mode, this field becomes the SSID of
the AP you want to connect with.
Default: WDRT-1200AC_5G
 Wireless Mode:
Set the wireless mode to which you need. Default is “802.11a/n/ac”. It
is strongly recommended that you set the Band to “802.11a/n/ac”, and
all of 802.11a, 802.11n, and 802.11ac wireless stations can connect to
the WDRT-1200AC.
 802.11a: 802.11a mode, rate is up to 54Mbps
 802.11n: 802.11n mode, rate is up to 300Mbps(2T2R)
 802.11a/n/ac: 802.11a/n/ac mode, rate is up to 867Mbps
 Wireless Channel:
For an optimal wireless performance, you may select the least
interferential channel. It is advisable that you select an unused channel or
“Auto” to let device detect and select the best possible channel for your
wireless network to operate on from the drop-down list.
 Bandwidth:
Select a proper channel bandwidth to enhance wireless performance.
When there is 11a/n/ac, please select 20/40/80MHz frequency band.
 Protected Mode: Protected mode is used when lots of 802.11b traffic is nearby.
 802.11e/WMM QoS: Enable or disable QoS features.
 Security Options:
Select the security mode from the Security Options dropdown list.
There are 5 options in the Security Mode dropdown list:
 None
 WEP
 WPA-PSK[TKIP]
 WPA2-PSK[AES]
 WPA-PSK[TKIP]+WPA2-PSK[AES]