PLANET WDRT-1200AC - Manual (Page 48)

User Manual of WDRT-1200AC
-42-
Network:
 Enable SSID
Broadcast:
You may choose to enable or disable SSID broadcast. When it is enabled,
the router SSID will be broadcast in the wireless network, so that it can be
scanned by wireless clients and they can join the wireless network with
this SSID.
 Enable Wireless
Isolation:
Enable or disable Wireless Isolation function.
 SSID:
Set a name (SSID) for your wireless network. The ID of the wireless
network. User can access the wireless network through it only. However,
if you switch to Client Mode, this field becomes the SSID of the AP you
want to connect with.
Default: WDRT-1200AC_2.4G
 Wireless Mode:
Set the wireless mode to which you need. Default is “802.11b/g/n”. It is
strongly recommended that you set the Band to “802.11b/g/n”, and all of
802.11b, 802.11g, and 802.11n wireless stations can connect to the
WDRT-1200AC.
 802.11b: 802.11b mode, rate is up to 11Mbps
 802.11g: 802.11g mode, rate is up to 54Mbps
 802.11n: 802.11n mode, rate is up to 300Mbps(2T2R)
 802.11b/g/n: 802.11b/g/n mode, rate is up to 11Mbps, 54Mbps, or
300Mbps
 Wireless Channel:
For an optimal wireless performance, you may select the least
interferential channel. It is advisable that you select an unused channel or
“Auto” to let device detect and select the best possible channel for your
wireless network to operate on from the drop-down list.
 Extension Channel: The extension Channel is over or under the primary Channel.
 Bandwidth:
Select a proper channel bandwidth to enhance wireless performance.
When there are 11b/g and 11n wireless clients, please select the 802.11n
mode of 20/40M frequency band.
 Protected Mode: Protected mode is used when lots of 802.11b traffic is nearby.
 802.11e/WMM QoS: Enable or disable QoS features.
 Security Options:
Select the security mode from the Security Options dropdown list. There
are 5 options in the Security Mode dropdown list:
 None,
 WEP
 WPA-PSK[TKIP]
 WPA2-PSK[AES]
 WPA-PSK[TKIP] + WPA2-PSK[AES]