PLANET WGSD-10020HP - Manual (Page 23)

User’s Manual of WGSD-10020 Series
2.1.3 Switch Rear Panel
The rear panel of the Managed Switch indicates an AC inlet power socket, which accepts input power from 100 to 240V AC,
50-60Hz. Figure 2-5 and Figure 2-6 show the rear panel of these Managed Switches.
WGSD-10020 Rear Panel
Figure 2-5 Rear panel of WGSD-10020
WGSD-10020HP Rear Panel
Figure 2-6 Rear panel of WGSD-10020HP
■ AC Power Receptacle
For compatibility with electrical supply in most areas of the world, the Managed Switch’s power supply automatically adjusts
to line power in the range of 100-240V AC and 50/60 Hz.
Plug the female end of the power cord firmly into the receptacle on the rear panel of the Managed Switch and the other end
of the power cord into an electrical outlet and then power it on.
Power Notice:
The device is a power-required device, meaning it will not work till it is powered. If your network should
be active all the time, please consider using UPS (Uninterrupted Power Supply) for your device. It will
prevent you from network data loss or network downtime.
In some areas, installing a surge suppression device may also help to protect your Managed Switch
from unregulated surge or current to the Switch or the power adapter.
■ Console Port
The console port is a DB9, RS-232 male serial port connector. It is an interface for connecting a terminal directly. Through
the console port, it provides rich diagnostic information including IP address setting, factory reset, port management, link
status and system setting. Users can use the attached RS-232 cable in the package and connect to the console port on the
device. After the connection, users can run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix,
Winterm and so on) to enter the startup screen of the device.
23