PLANET GSW-1602SF - Manual (Page 57)

User’s Manual of GSW-1602SF / GSW-2404SF
4.5.2 LACP Port Configuration
Link Aggregation Control Protocol (LACP) - LACP LAG negotiate Aggregated Port links with other LACP ports located on
a different device. If the other device ports are also LACP ports, the devices establish a LAG between them.
The LACP Port Configuration page contains fields for assigning LACP properties to individual ports. The screen in Figure
4-35 appears.
Figure 4-35 LACP Port Configuration
The page includes the following fields: table 4-11 description of the LACP Port Configuration.
• Item Description
Port Indicate port 1 to port 24 (GSW-24024SF), port 1 to port 16 (GSW-1602SF).
Key Mode Provide “Auto” or “Customer” for selection. Default is “Auto”.
LACP Enable To Enable or disable the LCAP protocol on a selected port. Once the LACP protocol be
enabled, the system will start transmit the LACP control packets and exchange with another
LACP aware switch. If the linked switch didn’t support LACP, then the aggregated link will not
be established.
Key Value Once set “Customer” in Key Mode, the Key Value will be filed in the LACP control packets.
Ports with same key value will be set to the same LACP Group. If two ports are set with
different key value, they will become two different LCAP groups. The key value will also be
the identify ID to the linked LACP switch.
The default setting is “0” and the available range is 1-255.
Role Provide “Active” or “Passive” for selection. Default is “Active”.
Button
-51-