PLANET GSW-1602SF - Manual (Page 45)

User’s Manual of GSW-1602SF / GSW-2404SF
4.3.2 System Configuration
The SNMP System Configuration page provides SNMP parameters. SNMP System Configuration page helps a switch
manager to configure SNMP functions. The screen in Figure 4-27 appears.
Figure 4-27 SNMP System Configuration screen
The page includes the following configurable data; see the table 4-3 description of the SNMP System Configuration.
Item Description
Mode Enable or Disable the SNMP function of the device. While set to enable, the manager could
remotely get the interface status and received the traps information. Default mode is Enable.
Read Community Functions as a password and used to authenticate the access right of the device. The Read
Community is restricted to read-only, for all MIBs except the community table, for which there
is no access. Up to 8 characters is allowed.
Write Community Functions as a password and used to authenticate the access right of the device. The Write
Community accesses the device both read and write - configure to the device via SNMP. Up
to 8 characters is allowed.
Trap Community Identifies the community string of the trap manager. Up to 8 characters is allowed.
Trap Destination The Trap function enables the Switch to monitor the Trap through the SNMP software, set the
Trap IP Address of the manager workstation where the trap to be sent
Button
Apply Press this button for save current configuration of Web Smart Gigabit Switch.
Refresh Press this button for refresh System Configuration screen of Web Smart Gigabit Switch.
Table 4-3 Description of the SNMP System Configuration
-39-