Avago Technologies LSI20320 - Manual (Page 34)

28 Fusion-MPT FCode User’s Guide
Copyright © 2000-2004 by LSI Logic Corporation. All rights reserved.
5.1.5 show-children
While you have the adapter or port selected, use the show-children
command to display the devices currently connected to this adapter.
Note that IM volumes are considered children of the adapter port, and
therefore this command is used to show physical disks or volume sets:
ok show-children
MPT Version 1.02, Firmware Version 0.00.09.00
Initiator ID is 7
Target 1
Unit 0 Disk SEAGATE ST336737LC 5040 71132960 Blocks, 36 GB
Target 2
Unit 0 Disk SEAGATE ST336737LC 5040 71132960 Blocks, 36 GB
5.1.6 show-volumes
The show-volumes OpenBoot command is used to display the currently
configured volumes. If no volumes have been configured an error
message is displayed, as shown in this example:
ok show-volumes
No volumes to show
5.1.7 create-volume
The create-volume OpenBoot command is used to create an IM volume
from two physical disks. After the command completes, the new IM
Volume can be displayed by the show-children command. To see the
members of a set, use the show-volumes command.
ok 0 1 2 create-volume
Target 1 size is 71132960 Blocks, 36 GB
Target 2 size is 71132960 Blocks, 36 GB
The volume can be any size from 1 MB to 36420 MB
What size do you want? [36420]
Volume 0 size will be 71132960 Blocks, 36 GB
PhysDisk 0 has been created for target 1
PhysDisk 1 has been created for target 2
Volume 0 has been created
The syntax for the create-volume command is as follows:
[volume ID] [first member] [second member] create-volume