Avago Technologies LSI20320 User Manual
Page 29
Fusion-MPT FCode Fibre Channel Commands
23
Copyright © 2000-2004 by LSI Logic Corporation. All rights reserved.
ok show-disks
a) /pci@1f,0/pci@1/IntraServer,fc@2/disk
b) /pci@1f,0/pci@1/IntraServer,Ultra2-scsi@1/disk
c) /pci@1f,0/pci@1,1/ide@3/cdrom
d) /pci@1f,0/pci@1,1/ide@3/disk
e) /pci@1f,0/pci@1,1/ebus@1/fdthree@14,3203f0
q) NO SELECTION
Enter Selection, q to quit: a
/pci@1f,0/pci@1/IntraServer,fc@2/disk has been selected.
Type ^Y ( Control-Y ) to insert it in the command line.
e.g. ok nvalias mydev ^Y for creating devalias mydev for
/pci@1f,0/pci@1/IntraServer,fc@2/disk
ok select /pci@1f,0/pci@1/IntraServer,fc@2
ok show-topology
Topology selected is auto
Current topology is unknown (no link)
ok set-topology <-
Command with no options provides help
usage is
topology = 1 NL_Port
topology = 2 N_Port
topology = a auto
ok 1 set-topology
Topology selected is NL_Port
Topology has been set
Change will take effect after system power cycle
ok 2 set-topology
Topology selected is N_Port
Topology has been set
Change will take effect after system power cycle
ok a set-topology
Topology selected is auto
Topology has been set
Change will take effect after system power cycle
Note:
The system must be power cycled for the changes to take
effect. It is not sufficient to execute the reset-all command.