Avago Technologies LSI20320 - Manual (Page 20)

14 Fusion-MPT FCode User’s Guide
Copyright © 2000-2004 by LSI Logic Corporation. All rights reserved.
4.2.1 show-devs
ok show-devs
/SUNW,UltraSPARC-III@0,0
/virtual-memory
/memory@m0,0
/aliases
/options
/openprom
/chosen
/packages
/upa@8,480000/SUNW,ffb@0,0
...
/pci@8,700000/IntraServer,fc@2
/pci@8,700000/IntraServer,fc@1,1
/pci@8,700000/IntraServer,fc@1
...
/pci@8,700000/IntraServer,fc@2/disk
/pci@8,700000/IntraServer,fc@2/tape
/pci@8,700000/IntraServer,fc@1,1/disk
/pci@8,700000/IntraServer,fc@1,1/tape
/pci@8,700000/IntraServer,fc@1/disk
/pci@8,700000/IntraServer,fc@1/tape
/pci@8,700000/scsi@6,1/tape
/pci@8,700000/scsi@6,1/disk
ok
•
/pci@8,700000/IntraServer,fc@1
identifies the first Fibre Channel interface on an LSI Logic 929 based
adapter.
•
/pci@8,700000/IntraServer,fc@1,1
identifies the second Fibre Channel interface on an LSI Logic 929
based adapter.
•
An LSI Logic 909 based Fibre Channel adapter shows only one such
Fibre Channel device.
Note: The above are examples. The output of the show-devs
command varies depending on your system and its
configuration. Use the corresponding entries on your
system, not the ones given in the examples.
If these devices are not listed, check that the adapter is correctly
installed, and re-seat the adapter if necessary.