Select – Avago Technologies LSI20320 User Manual

Page 12

Fusion-MPT FCode User’s Guide

To select a specific Fusion-MPT adapter as the current adapter, use the
select command. Selecting a port or adapter brings the port online and
allows you to show or set certain adapter specific parameters.

Use caution when you issue the following commands. Using the
commands incorrectly could make the bus unusable—for example,
forcing the SCSI initiator ID to one that conflicts with another device on
the bus.

3.3.1

select

Use the select OpenBoot command to select the adapter entry. This
opens the port to bring the port online:

ok select /pci@1f,0/pci@1/pci@1/LSILogic,scsi@c

Note:

Some versions of Sun Microsystem’s OpenBoot console do
not implement the select command. Use the following
syntax if the select command is not supported. Be sure to
include the space after each quotation mark:

ok " /pci@1f,0/pci@1/pci@1/LSILogic,scsi@c" select-dev

This manual is related to the following products:

LSI20320-R LSI21320-R LSI22320-R LSIU320 LSIU320 (Channel)