Avago Technologies LSI20320 - Manual (Page 25)

Fusion-MPT FCode Fibre Channel Commands 19
Copyright © 2000-2004 by LSI Logic Corporation. All rights reserved.
Pathing configuration option. Note that after selecting a different option,
the chip must be reset in order for the change to take effect.
LSI Logic has determined that these settings are optimal for a wide
variety of situations. LSI Logic also provides a mechanism to modify
these values and write them to the nonvolatile EEPROM on the adapter.
Select the port or adapter shown (use the port name your system
assigns):
ok show-disks
a) /pci@1f,0/pci@1/LSILogic,scsi@3,1/disk
b) /pci@1f,0/pci@1/LSILogic,scsi@3/disk
c) /pci@1f,0/pci@1/IntraServer,fc@2,1/disk
d) /pci@1f,0/pci@1/IntraServer,fc@2/disk
e) /pci@1f,0/pci@1,1/ide@3/cdrom
f) /pci@1f,0/pci@1,1/ide@3/disk
g) /pci@1f,0/pci@1,1/ebus@1/fdthree@14,3203f0
q) NO SELECTION
Enter Selection, q to quit: d
/pci@1f,0/pci@1/IntraServer,fc@2/disk has been selected.
Type ^Y ( Control-Y ) to insert it in the command line.
e.g. ok nvalias mydev ^Y
for creating devalias mydev for
/pci@1f,0/pci@1/IntraServer,fc@2/disk
ok select /pci@1f,0/pci@1/IntraServer,fc@2
ok words
show-children diagnose get-scsi-type read-capacity
print-capacity probe-target short-data-command
short-data-command-retries no-data-command
no-data-command-retries retry-command close open
decode-unit update-flash enable-volume disable-volume
delete-volume create-volume show-volumes set-sort-by-did
set-sort-by-wwn show-sort-by set-topology
show-topology set-multi-pathing show-multi-pathing
set-link-speed show-link-speed
set-interrupt-coalescing show-interrupt-coalescing
clear-persistent-all clear-persistent
set-persistent show-persistent
disable-event-notification enable-event-notification
debug-csr-off debug-csr-on debug-off debug-on reset
selftest execute-command reset-all-ports
reset-scsi-bus timeout? set-timeout timeout
set-address lun target close-hardware
reclose-hardware open-hardware reopen-hardware
print-config unmap map chip1-base
chip-base max-transfer dma-map-out dma-map-in dma-free
dma-alloc