Avago Technologies LSI20320 - Manual (Page 11)

Fusion-MPT FCode SCSI Commands 5
Copyright © 2000-2004 by LSI Logic Corporation. All rights reserved.
3.2.1 show-devs
ok show-devs
/SUNW,UltraSPARC-III@0,0
/virtual-memory
/memory@m0,0
/aliases
/options
/openprom
/chosen
/packages
/upa@8,480000/SUNW,ffb@0,0
...
/pci@1f,0/pci@1/pci@1/LSILogic,scsi@c,1
/pci@1f,0/pci@1/pci@1/LSILogic,scsi@c…
/pci@1f,0/pci@1/pci@1/LSILogic,scsi@c,1/disk
/pci@1f,0/pci@1/pci@1/LSILogic,scsi@c,1/tape
/pci@1f,0/pci@1/pci@1/LSILogic,scsi@c/disk
/pci@1f,0/pci@1/pci@1/LSILogic,scsi@c/tape
ok
•
/pci@1f,0/pci@1/pci@1/LSILogic,scsi@c
identifies the first Ultra320 SCSI interface on an LSI Logic 1030
based adapter.
•
/pci@1f,0/pci@1/pci@1/LSILogic,scsi@c,1
identifies the second Ultra320 SCSI interface on an LSI Logic 1030
based adapter.
•
An LSI Logic 1020 Ultra320 SCSI adapter shows only one such
SCSI device.
Note: The above are examples. The output of the show-devs
command varies depending on your system and its
configuration. Use the corresponding entries on your
system, not the ones given in the examples.
If your SCSI devices are not listed, check that the adapter is correctly
installed, and reseat the adapter if necessary.
3.3 SCSI Adapter Specific Settings
In certain circumstances, the advanced user may want to change
settings for an individual adapter or port, without affecting the other
adapters in the system. Specific examples of such settings are SCSI
initiator ID and Interrupt Coalescing.