Avago Technologies LSI20320 User Manual
Page 17
Fusion-MPT FCode SCSI Commands
11
Copyright © 2000-2004 by LSI Logic Corporation. All rights reserved.
The following is an example of how to set the port-specific OpenBoot
scsi-initiator-id using the Fusion-MPT FCode. Refer to your platform
OpenBoot code for the system-wide scsi-initiator-id. Refer to your Solaris
driver documentation for information on setting the itmpt.conf
scsiinitiator-id. It is strongly recommended that you chose the appropriate
location for setting the scsi-initiator-id and that you not try to change it in
multiple places.
ok select /pci@1f,0/pci@1/pci@1/LSILogic,scsi@c
ok show-initiator-id
Initiator ID has not been set; the default value is in effect
Initiator ID is 7
ok 8 set-initiator-id
Initiator ID has been set
Change will take effect immediately
ok show-initiator-id
Initiator ID is 8
ok unset-initiator-id
Initiator ID has been unset; the default value is in effect
Change will take effect immediately
ok show-initiator-id
Initiator ID has not been set; the default value is in effect
Initiator ID is 7