Avago Technologies LSI20320 - Manual (Page 18)

12 Fusion-MPT FCode User’s Guide
Copyright © 2000-2004 by LSI Logic Corporation. All rights reserved.
4 Fusion-MPT FCode Fibre Channel Commands
4.1 Identifying the Fibre Channel Disks
The probe-scsi-all command is used to identify the Fibre Channel
devices on your Fusion-MPT adapter.
Use the probe-scsi-all command to show all disks available from the
OpenBoot prompt. All Fibre Channel or SCSI disks available on all
Fusion-MPT devices will be displayed.
4.1.1 probe-scsi-all
ok probe-scsi-all
/pci@8,600000/SUNW,qlc@4
LiD HA LUN --- Port WWN --- ----- Disk description -----
1 1 0 2100002037e4d65b SEAGATE ST318304FSUN18G 0726
/pci@8,700000/IntraServer-Ultra160,scsi@3,1
/pci@8,700000/IntraServer-Ultra160,scsi@3
Target 0
Unit 0 Disk IBM DDRS-34560D DC1B
/pci@8,700000/IntraServer,fc@2
MPT Version 1.00, Firmware Version 1.02.00
Link is ready, port is online
WWN 100000a0b8040353 Port ID ef
Target 0
Unit 0 Disk SEAGATE ST39173FC 6615
WWN 2100002037109d76 Port ID d9
Target 1
Unit 0 Disk SEAGATE ST39173FC 6615
WWN 210000203710565a Port ID 17
Target 2
Unit 0 Disk SEAGATE ST39173FC 6615
WWN 2100002037105212 Port ID 1
pci@8,700000/scsi@6
Target 6
Unit 0 Removable Read Only device PLEXTOR CD-ROM PX-20TS