Epson 715c - Manual (Page 31)

22 Using the Projector
6. Do one of the following:
■ If you’re presenting without a computer, you may see the
EasyMP main screen. Use the
Enter button on the remote
control to select your presentation, then press Enter to start
it. See Chapter 5 for more information.
If a presentation starts automatically, you may need to press
Enter to change slides.
■ If you’re using a computer, turn it on or restart it. In a few
moments, you should see your computer display projected. If
you see an EasyMP screen or presentation instead, press the
Source button on top of the projector to switch to the
computer.
(Windows ® only: If you see a message saying that it has found
a plug-and-play monitor, click Cancel .)
■ If you’re projecting a video, press the Source button on top
of the projector to switch to your video source, and press the
Play button on your DVD player or other device.
If a projected image fails to appear, see the next section for help.
Once you see your image, turn to page 24 for instructions on focusing
and making other image adjustments.
When you’re done with your presentation, shut down the projector as
described on page 27. Shutting down the projector correctly prevents
premature lamp failure and possible damage from overheating.
What To Do If You See a Blank Screen
If you see a blank screen or a blue screen with the message No Signal
after turning on your computer or video source, try the following:
■ Make sure the cables are connected correctly, as described on
page 12 (for laptops) or in Appendix A (for other systems).
■ Make sure the power light is green and not flashing and the lens
cover is off.
■ Try restarting your computer.