Extron electronic Twisted Pair Receiver VTR001 - Manual (Page 26)

VTT001 and VTR001 • Installation
Installation, cont’d
2-14
AAP mounting
The AAP versions of the VTT001 (VTT001 AAP) and VTR001
(VTR001 AAP) are mounted to the Extron AAP panel by
inserting the two AAP studs through the panel mounting holes
and attaching the nuts.
Cable
Cable
Clamp
VTT001 AAP
AAP 102
AA P 10 2
#4-40 Nut w/ Captive
Washer
IN PU T
VTT001 AAP
Figure 2-10 — Attaching a VTT001 AAP to an Extron
AAP frame
UL rack mounting guidelines
The following Underwriters Laboratories (UL) guidelines
pertain to the safe installation of the device in a rack.
1. Elevated operating ambient temperature — If installed in
a closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment may be
greater than room ambient temperature. Therefore,
install the unit in an environment compatible with the
maximum ambient temperature (Tma = +122 °F, +50 °C)
specified by Extron.
2. Reduced air flow — Install the equipment in a rack so that
the amount of air flow required for safe operation of the
equipment is not compromised.
3. Mechanical loading — Mount the equipment in the rack
so that a hazardous condition is not achieved due to
uneven mechanical loading.